Water Treatment Services
Testing, design, installation, compliance documentation and scheduled maintenance for industrial and commercial water systems.
1 · Industrial Water Treatment
Feedwater and process water for boilers, cooling towers, chillers, CIP loops and wastewater pre-treatment. Ion exchange, dealkalization, chemical feed, degasification and reverse osmosis, sized against your actual duty cycle rather than a catalogue guess.
- Boiler feedwater softening and dealkalization
- Cooling tower control and side-stream filtration
- Industrial RO from 2,000 to 100,000 GPD
- pH neutralisation and effluent pre-treatment
2 · Commercial Filtration
Packaged systems for buildings where water quality shows up in the product: kitchens, coffee programmes, laundries, dental and dialysis suites, car washes, hotels and office campuses.
- Water softeners with metered regeneration
- Carbon and multi-media filtration
- Point-of-use and point-of-entry RO
- UV disinfection and scale inhibition
3 · Water Testing & Analysis
Field sampling by our technicians, then a certified third-party laboratory panel. You get the raw results plus an interpretation of what they mean for your equipment.
- Hardness, alkalinity, pH, TDS, conductivity
- Iron, manganese, silica, chlorides, sulphates
- Coliform and heterotrophic plate counts
- Langelier and Ryznar scaling indices
4 · Compliance Reporting
Documentation that survives an inspection: equipment records, NSF/ANSI component listings, service logs, pre-treatment permit support and ADEM/EPA-formatted summaries.
- Industrial pre-treatment permit paperwork
- Annual water quality summaries
- Chemical inventory and SDS binders
- Calibration and verification records
5 · Service & Maintenance
Quarterly, monthly or weekly routes depending on load. Resin and media change-outs, membrane cleaning, brine valve rebuilds, controller programming and 24/7 emergency call-out.
- Preventive maintenance agreements
- Media and resin replacement
- Membrane clean-in-place and replacement
- Emergency repair, nights and weekends
6 · Efficiency Retrofits
Most systems we inspect are wasting water, salt or gas. Retrofits pay for themselves through metered regeneration, correct sizing, blend valves, condensate return and better controls.
- Time-clock to meter-initiated conversions
- Blend valve and hardness leakage tuning
- Condensate recovery and heat exchange
- Remote monitoring and alarm dial-out
Typical equipment we install
| System | Capacity range | Typical application | Service interval |
|---|---|---|---|
| Twin-alternating softener | 30–900 GPM | Boiler feed, laundries, process | Quarterly |
| Multi-media filter | 20–600 GPM | Turbidity, sediment, iron | Semi-annual |
| Activated carbon filter | 10–400 GPM | Chlorine, taste, odour, organics | Annual media change |
| Industrial RO skid | 2,000–100,000 GPD | Low-TDS process and rinse water | Quarterly + CIP |
| Dealkalizer | 15–500 GPM | Steam boilers, condensate protection | Quarterly |
| UV disinfection | 5–300 GPM | Food, beverage, clinical water | Annual lamp change |
Capacities shown are indicative. Final sizing always follows a site assessment and water analysis.
Not sure which service you need?
Start with a water test. It costs you nothing inside our territory and the results are yours regardless of whether you buy anything.
Request a water test